Page 1 of 1

Telnetd.device Unit 1

PostPosted: Fri Dec 18, 2015 11:45 pm
by Black Beard
If you are setting up telnetd.device I would recommend the following:

Top speed should be = 19200
Always setup your first telnet node as unit 1
(Do not use 0)
and continue on for additional nodes: 2,3 etc..

Black Beard

Re: Telnetd.device Unit 1

PostPosted: Fri Sep 09, 2016 9:16 pm
by Firestone
Why not unit 0 ?
I have used it for nearly two decades....?

Re: Telnetd.device Unit 1

PostPosted: Fri Sep 09, 2016 11:30 pm
by Black Beard
I have run into some odd issues when using unit 0 for my local node.
It usually occurs in installations with 2+ telnet nodes.
I forget what the issue is, but I think the node wouldn't answer properly.
Just out of curiosity how many nodes are you running?


Black Beard

Re: Telnetd.device Unit 1

PostPosted: Mon Sep 26, 2016 5:59 pm
by Firestone
I'm running 5 nodes, but this is in the ABBS Bulletin Board system, not AmiExpress. Running 5 nodes.

My main problem is those botnets banging on port 23 all the time which results in crashing the nodes at the end....
Do you have a problem with this?

Re: Telnetd.device Unit 1

PostPosted: Tue Sep 27, 2016 11:44 am
by Black Beard
I will start a new post with how to keep your bbs up and running.